The archive (see below) contains all the necessary and correctly configured configuration files for the Mgcamd emulator optimized for our server.
If you already have the Mgcamd emulator installed, then having unzipped and copied these configuration files to the receiver's / var / keys / folder, your receiver is almost ready to work. All that remains is to add the automatically generated CWS lines from billing (the "my subscription" section) to the end of the newcamd.list file, reload the emulator and enjoy viewing.
With these settings, the channels will switch quickly, the connection to the server will not be disconnected, and most importantly, the server will not block IP for violating the rules of "frequent reconnections to the server".
ATTENTION !!!! Be sure to replace mg_cfg file beforein your receiver, see which parameter B: {XX} is set in the original mg_cfg file. This parameter is responsible for determining the type of receiver. By default, the parameter is set to B: {00} - the receiver is automatically detected and works on most receivers. Nevertheless, there is a certain part of cheap receivers (clones) that the emulator is not able to determine and then the parameter must be set manually.
Possible variations are B: {XX} 00 to 12
# box type
# 00 autodetect, change only if you think wrong type detected.
# 01 dbox2
# 02 dreambox E1
# 03 triple-dragon
# 04 relook
# 05 openbox
# 06 dreambox / mips / GI-SPARK /Xtrend ET600
# 08 stapi / kathrein
# 09 stapi / ipbox
# 11 stapi / openbox-Enigma2 , IPbox Enigma2 / GI-Enigma2
# 12 stapi / IPbox DGS, openbox Sxx, Skyway FORTYS & others
######################################################
Files updated: 09/21/2016
mgcamd_config_15052017.zip (2.1 kB)
